Features and Characteristics
Overall Width
0.6693 inches
Bore Diameter
0.9843 inches
Overall Outside Diameter
2.4409 inches
Retainer Fabrication Method
Machined
Locating Feature
Two direction
Internal Clearance
0.0007 inches radial and 0.0022 inches radial
Standard Tolerance Designation
Rbec no.5
Special Features
Inner ring w/2 slots opposite to lip, 180 degrees apart 0.067 in. W by 0.033in. Dp, 0.250 in. Radius one point of separable inner ring bore
Material
Steel side plate
Material Specification
Ams 6276 assn standard single material response side plate
Test Data Document
73342-eis1003 specification (includes engineering type bulletins, brochures, etc., that reflect specification type data in specification format; excludes commercial catalogs, industry directories, and similar trade publications, reflecting general type data on certain environmental and performance requirements and test conditions that are shown as "typical", "average", "", etc.). And 73342-eis15a22 specification (includes engineering type bulletins, brochures, etc., that reflect specification type data in specification format; excludes commercial catalogs, industry directories, and similar trade publications, reflecting general type data on certain environmental and performance requirements and test conditions that are shown as "typical", "average", "", etc.). And 73342-eis11a69 specification (includes engineering type bulletins, brochures, etc., that reflect specification type data in specification format; excludes commercial catalogs, industry directories, and similar trade publications, reflecting general type data on certain environmental and performance requirements and test conditions that are shown as "typical", "average", "", etc.). And 73342-eis10a17 specification (includes engineering type bulletins, brochures, etc., that reflect specification type data in specification format; excludes commercial catalogs, industry directories, and similar trade publications, reflecting general type data on certain environmental and performance requirements and test conditions that are shown as "typical", "average", "", etc.).
FSC
3110 Unmounted Antifriction Bearings